管道煤气热式质量流量计研制和标定技术研究.pdf

第 3 4 卷 第 3 期 哈 尔 滨 工 业 大 学 学 报 Vol . 3 4 No . 3 　　　　　 　 　　　　　　　 　 2 0 0 2 年 6 月 Journal of Harbin Institute of Technology Jun . , 2 0 0 2 管道煤气热式质量流量计研制及标定技术研究 李成伟 , 李朝辉 , 戴景民, 陈守仁 ( 哈尔滨工业大学 电气工程及 自动化学院 ,黑龙江 哈尔滨 ,150001) 摘 　要 :为解决目前燃气计量中仪表下限以下测量精度差或无法计量而造成漏计等问题 ,基于强制对流换热 理论和热线风速计原理 ,研制成功了新型气体质量流量计. 仪表中敏感元件和测速加热元件采用了微丝结构 , 测量线路中应用了副电桥技术 ,较大地提高了仪表的灵敏度 , 降低了仪表的死区. 由于煤气介质较特殊 ,影响 因素多 ,采用了实流标定. 通过大量实流标定实验 ,分析了煤气导热系数对标定结果的影响 ,并提出了一种新 的补偿方法. 经实验测试 ,仪表可做到几乎零下限 ,有效地解决了煤气计量的漏计问题. 关键词 :对流换热理论 ;热式质量流量计 ;实流标定 ;导热系数补偿 ( ) 中图分类号 : TH814. 6 　　文献标识码 :A 　　文章编号 :0367 - 6234 2002 03 - 0333 - 04 Development and calibration of thermal gas mass flowmenter for pipe gas L I Chengwei , L I Chaohui , DAI Jingmin , CHEN Shouren ( School of Electrical Engineering Automation , Harbin Institute of Technology ,Harbin 150001 , China) Abstract : In order to solve the gas flowmeter ’s lower limit problems , such as low accuracy at lower limit or the small gas flow leakage ,a novel gas flowmenter based on the compelled forced convection principle and the principle of hot - wire anemometer has been successfully developed ,in which ,micro hot - wires are used as sensitive ele ments ,a resistive heater is used for measurement of gas flow rate ,and a support bridge technology is adopted in the measuring circuit . The sensitivity of the meter has been improved and the dead space in it has been reduced . Pipe gas is an especial substance ,its measurement precision is affected by many factors ,the flowmeter must