焊接规范(英文版).doc

Standard of Ministry of Electrical Power P.R. China The Specification of Erection and Acceptance for Power Plant Construction Welding Section (DL5007-92) 1991-12-31 Issue 1992-09-1 Execution Issue by Ministry of Electrical Power P.R. China CONTENTS Chapter 1 General Chapter 2 Welding personnel Chapter 3 Base metal welding materials Chapter 4 Preparation before welding Chapter 5 Welding technology Chapter 6 Post-weld heat treatment Chapter 7 Quality inspection Chapter 8 Quality criterion Chapter 9 Technical documentation Appendix A Chemical composition, mechanical properties and reference data of steel commonly used in power plants Appendix B Chemical composition and mechanical properties of filler metal that commonly used welding electrodes Appendix C Chemical composition of commonly used welding wires Appendix D Abridged data of commonly used welding flux for automatic submerged arc welding Appendix E Recommended welding electrodes (wires) for welding different kinds of steel and post-weld heat treatment temperatures Appendix F Parts to be cut and specifications of specimens for quality inspection of welding joints Chapter 1 General 1.0.1 This specification is applicable to the welding work of boiler, pressure piping, vessels and steel structures in the design , fabrication, erection and maintenance of thermal power generating plant (with unit capacity ≒600MW) of electrical power industry . 1.0.2 This specification is applicable to the welding technologies of manual arc welding, tungsten argon arc welding, flame gas welding and automatic submerged arc welding on carbon steel (with carbon content≒0.35%), common low-alloy steel and heat resisting steel. For other materials and welding technologies, technical requirements shall be drawn up according to this specification and relevant technical standards. 1.0.3 The erection acceptance of foreign electrical power units shall be carried out according to