cisco6509配置.doc

1. 连接设备 1.1. 从console连接 第一次对6000交换机进行配置，必须从console进入。　 首先先将机器上架，按要求接好电源，然后用随机附带的Console线和转接头将交换机的console口与PC的串口相联，如下： Com口设置如下： ? 9600 baud ? 8 data bits ? No parity ? 2 stop bits 检查电源无误后，开电，可能会出现类似下面的显示，按黑粗体字回答: System Bootstrap, Version 6.1(2) Copyright (c) 1994-2000 by cisco Systems, Inc. c6k_sup2 processor with 131072 Kbytes of main memory rommon 1 boot slot0:c6sup22-jsv-mz.121-5c.EX.bin Self decompressing the image : ################################################# ############################################################################### ############################################################################### ############################################################################### ############################################################################### [OK] Restricted Rights Legend Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c) of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013. cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706 Cisco Internetwork Operating System Software IOS (tm) MSFC2 Software (C6MSFC2-BOOT-M), Version 12.1(3a)E4, EARLY DEPLOYMENT R ELEASE SOFTWARE (fc1) Copyright (c) 1986-2000 by cisco Systems, Inc. Compiled Sat 14-Oct-00 05:33 by eaarmas Image text-base: 0 data-base: 0x303B6000 cisco Cat6k-MSFC2 (R7000) processor with 114688K/16384K bytes of memory. Processor board ID SAD04430J9K R7000 CPU at 300Mhz, Implementation 39, Rev 2.1, 256KB L2, 1024KB L3 Cache Last reset from power-on X.25 software, Version 3.0.0. 509K bytes of non-volatile configuration memory. 16384K bytes of Flash internal SIMM (Sector size 512K). Press RETURN to get started! --- System Configuration Dialog --- Would you like to enter the initial dialog? [yes]: no 回答：NO，进入手工配置，在router下，输入enable 回车，进入