sun cluster 常用命令.doc

Sun Cluster 3 Command Summary Cluster Node Operations Operation Command Example Boot a node - none cluster mode boot -x (At ok prompt) ok boot -x Stopping a node 1. scswitch scswitch -S -h nodeA (switch resources) 2. shutdown shutdown -y -g30 -i0 Rebooting a node 1. scswitch scswitch -S -h nodeA (switch resources) 2. shutdown shutdown -y -g30 -i6 Disable quorum vote for a node scconf scconf -c -q node=nodeA,maintstate Stopping the cluster scshutdown scshutdown -y -g10 Display status information scstat scstat [ -pvv ] Display quorum information scstat scstat -q Display cluster configuration scconf scconf -p [ -pvv ] Check the cluster configuration sccheck sccheck -v Backup the cluster configuration tar tar -cv /etc/cluster/ccr Restore the cluster configuration 1. scshutdown 1. scshutdown -y -g0 2. boot 2. ok boot -sx 3. tar 3. tar -xv Cluster Quorum Device Operations Operation Command Example Display quorum information scstat scstat -q Remove a quorum device scconf scconf -r -q globaldev=d30 Add a quorum device scconf scconf -a -q globaldev=d12 Put into maintenance state scconf scconf -c -q globaldev=d15,maintstate Bring out of maintenance state scconf scconf -c -q globaldev=d15,reset Veritas Volume Manager Operations Operation Command Example Add disk group to cluster scconf scconf -a -D type=vxvm,name=m-dg,nodelist=nodeA:nodeB Register change to disk group scconf scconf -c -D name=mydg,sync Switch device group to a node scswitch scswitch -z -D mydg -h nodeA (node to switch to) Check status scstat scstat -D Change properties scconf scconf -c -D name=mydg,nodelist=nodeA:nodeB, preferenced=true,failback=disabled Nafo Group Operations Operation Command Example Creating nafo group pnmset pnmset -c nafo0 -o create hme0 qfe0 Deleting nafo group pnmset pnmset -c nafo0 -o delete Adding a card pnmset pnmset -c nafo0 -o add qfe0 Removing card pnmset pnmset -c nafo0 -o remove qfe0 Switching active adaptor pnmset pnmset -