货油泵安装工艺.docVIP

在分段上安装前的条件 Condition before mounting on the subsection. 货油泵的基座按基座图安装到位. Seat for cargo pump must be installed completely, according to pump seat drawing 将泵安装到基座上，并且垫块拂配结束。 Put the pump on the seat and the chock must be finished. 垫块交船东认可，按图纸钻孔达到图纸规定尺寸。 Application inspection the chock to owner and surveyor. Boring the holes according to the drawing. 紧固货油泵联接螺栓。 Tighten cargo oil pump bolts. 在船台上安装前的条件 Condition before mounting on the slipway. 机舱EG43，EG41及EG42分段所有工作全部完工。 Welding work for block EG43, EG41 and EG42 must all be finished. 透平基座的安装步骤 Installation process of turbine foundation 泵舱顶平台的透平安装位置开Φ200孔。不能开到实际大小，开小孔以便于安装时调节整体误差。 Hole for cargo pump on pump room top platform first should be cut Φ200 in order to easy to adjust. 透平机基座放置到位，点焊。高度误差不超过±5mm。 The seat for turbine only need be touched welding. The permissible error of height no more than±5mm. 用铅垂从泵舱顶开孔处放下，校准货油泵基座中心位置以确定泵舱顶平台开孔圆心位置。 Align the center of cargo pump foundation with a plumb from the hole on pump room top, and then find the real center point of the hole. 根据已确定的圆心位置开Φ580孔。 Cut Φ580 hole according to the center of the hole that just found. 根据已确定的圆心位置确定透平基座位置，并将透平基座安装到位。高度误差不超过±5mm。 Install the foundation of the turbine completely according the center of the hole that just found. The permissible error of height no more than±5mm. 货油泵的安装步骤 Installation process of cargo pump 按图①所示加工一临时轴，确保两端法兰的同轴度不超过0.05。 Machining a temporary shaft refer to the figure ①，keep the same axial angle not more than 0.05mm. 将通舱联轴节与6420平台焊接，焊接过程中注意对称焊接，以防止不锈钢波纹管的变形。 Welding the intermediate shafting of penetration with the 6420 platform, to be prevent deformation give to the stainless bellow by welding must be keep symmetry welding. 将货油泵组按图②初步布置到位，同时用调整螺钉支承，将临时轴与货油泵固定并用联接螺栓固定,按照货油泵的输出轴来校正。 Installing the cargo oil pump and support by adjusting bolts, and fitting temporary shaft with cargo oil pump tightly by bolts，shaft alignment according to the output shaft of cargo oil pump. 根据图③所示将通舱件安装