串口收发.docVIP

串口收发 //头文件包含 #include stm32f10x.h #include platform_config.h GPIO_InitTypeDef GPIO_InitStructure; typedef enum { FAILED = 0, PASSED = !FAILED} TestStatus; #define TxBufferSize1 (countof(TxBuffer1) - 1)//定义UART1的发送缓冲器的字节数 #define TxBufferSize2 (countof(TxBuffer2) - 1)//定义UART2的发送缓冲器的字节数 #define RxBufferSize1 TxBufferSize2 #define RxBufferSize2 TxBufferSize1 #define countof(a) (sizeof(a) / sizeof(*(a)))//sizeof(a) = 数组字节长度 //sizeof(*(a)) = 数组变量类型(char = 1、int = 2) //数组长度=sizeof(数组)/sizeof(*数组) //数组长度=sizeof(数组)/sizeof(*数组)　（数组内为纯数字） //数组长度=sizeof(数组)-1/sizeof(*数组) （数组内为纯字符或者数字数组混和） //最后，那么调用宏定义，即可得出该数组内的字节数量：#define WriteBufferSize (countof(parameter_tab)) //WriteBufferSize就等于该数组内的字节数量。 USART_InitTypeDef USART_InitStructure;//定义串口初始化结构 uint8_t TxBuffer1[] = 串口中断收发示例: 串口1 - 串口2 (中断收发); uint8_t TxBuffer2[] = 串口中断收发示例: 串口2 - 串口1 (中断收发); uint8_t RxBuffer1[RxBufferSize1]; uint8_t RxBuffer2[RxBufferSize2]; __IO uint8_t TxCounter1 = 0x00; __IO uint8_t TxCounter2 = 0x00; __IO uint8_t RxCounter1 = 0x00; __IO uint8_t RxCounter2 = 0x00; uint8_t NbrOfDataToTransfer1 = TxBufferSize1; uint8_t NbrOfDataToTransfer2 = TxBufferSize2; uint8_t NbrOfDataToRead1 = RxBufferSize1; uint8_t NbrOfDataToRead2 = RxBufferSize2; __IO TestStatus TransferStatus1 = FAILED; __IO TestStatus TransferStatus2 = FAILED; /* Private function prototypes -----------------------------------------------*/ void RCC_Configuration(void);//时钟配置函数 void GPIO_Configuration(void);//GPIO口配置函数 void NVIC_Configuration(void);//中断配置函数 TestStatus Buffercmp(uint8_t* pBuffer1, uint8_t* pBuffer2, uint16_t BufferLength); int main(void) { RCC_Configuration(); NVIC_Configuration(); GPIO_Configuration(); GPIO_SetBits(GPIO_LED,DS1_PIN|DS2_PIN|DS3_PIN|DS4_PIN);//关闭所有的LED指示灯 USART_InitStructure.USART_BaudRate = 115200; //设置波特率为115200 USART_InitStructure.USART_WordLength = USART_WordLength_8b;//设置数据位为8 USART_InitStructure.USART_StopBits = USART_StopBits_1; //设置停止位为1位 USART_InitStructure