乌克兰 Pryroda LTD.docVIP

French German Italian Russian Spanish Portuguese Omega M200 Pryroda? Ltd91033 LuganskUkraine145g? Zveyneka str. Phone/Fax : +380 (642) 715042E-mail: pryroda@General director? Stepan Stetskov tel +38 050 3584455 (only russian)Svetlana V. Bondar tel +38 050 9570255 (english) a crystal growing furnace: sapphire single crystals of up to 200mm in diameter by Kyropoulos method Technical CharacteristicsWeight of the load of raw material in the melting pot, kg: 38.Temperature of molten material, Celsius: 2100.Hypobaric pressure in the chamber, Pa: 6x10-5Run of the rod, mm: 150.Working speed of the rod, mm/hour: 0,1-1,2Power consumption, kilowatt: 60, peak- kilowatt: 80.Cooling water debit, cubic meter/hour: 6,0.Inert gas debit, cubic meter/cycle: 0,2.Weight, kg 2108.Additional ParametersMethod of heating: resistive.Working environment: vacuum, Pa: 6х10-5The speed of the rod (the speed varies in 0,1mm/hour increments), mm/hour:- the lowest speed:? 0.1- the highest speed: 2.0Speed of the accelerated movement of the rod, mm/hour: 20;Accuracy of maintenance of the speed of the rod, %: ±2;Rotation frequency of the rod , rotations/min:- the lowest speed:1;- the highest speed: 4.Accuracy of stabilization of voltage on the heater:- in the range from 2,5V to 5V: ±2%;- in the range from 5V to 7V: ±1%;- in the range from 7V to 10V: ±0,1%.Installation requirementsA shop with the following parameters of microclimate:- temperature 20±5°С;- relative humidity below 90%;Also:- a premise of 9m2;- a sewer discharge at the floor level or lower with a conditional pass of at least 70mm;- a contour of grounding, with resistance value between the grounding bolt and any of accessible parts of the device should be 0.1ohm or lower.Operational supplies:Demineralized water under a pressure of 4х105±0.5х105Pa(Pascal). Water temperature must not be higher than 20±5°С; debit of water should be 3.5 m3/hour; Nitrogen gas, purified to the level required by GOST