压力容器垫片密封螺栓静强度安全系数的确定.doc

压力容器垫片密封螺栓静强度 安全系数的确定 刘小宁1，2 ，吴元祥1 ，李 清1 ，韩春鸣1 ，刘 兵1 ，袁小会1 ( 1． 武汉软件工程职业学院，湖北 武汉 430205; 2． 武汉工程大学，湖北 武汉 430074) 摘 要: 基于信息熵理论中模糊等效随机的原理，将压力容器垫片密封螺栓的模糊静强度和模糊载荷等效为随机 静强度和随机载荷，根据先漏后爆的观点和中国标准，分析了内压容器垫片密封螺栓模糊强度在不同工况时的许 用可靠度，建立按许用可靠度确定螺栓静强度安全系数的方法。对于内压容器垫片密封结构，研 究 表 明: ①在 预 紧、正常操作、气压试验与液压试验时，螺栓屈服强度许用可靠度分别为 0. 993 54、0. 993 54、0. 972 60 与 0. 792 5; 螺 栓抗拉强度许用可靠度分别为 0. 999 999 991 40、0. 999 999 991 40、0. 999 999 991 40 与 0. 999 990 226; ②螺栓屈服与 抗拉安全系数的最小值分别为 1. 50 与 2. 10。 关键词: 压力???器; 垫片密封; 螺栓静强度; 可靠度; 安全系数 中图分类号: TH 49 文献标识码: A 文章编号: 1004 － 8901( 2011) 05 － 0016 － 04 Safety Factor Determination for Static Strength of Bolts in Pressure Vessel Gasket Seal LIU Xiao-ning，WU Yuan-xiang，LI Qing，HAN Chun-ming，LIU Bing，YUAN Xiao-hui ( 1． Wuhan Soft Ware Engineering Profession College，Wuhan Hubei 430205 China; 2． Wuhan Engineering University，Wuhan Hubei 430074 China) Abstract: Based on vague equivalent random principle in message entropy theory，taking the vague static strength and vague load being equivalent to random strength and random load for bolts with gasket sealing in pressure vessel，as per the point of view of first leakage and then explosion and the Chinese standard，author has analyzed the permissible reliability for vague static strength of bolts with gasket sealing in pressure vessel，the method was established for determining the static strength safety factor of bolts as per permissible reliability． Concerning the gasket seal construction in pressure vessel， research indicates that : ①permissible reliabilities for yield strength of bolts in case of pre-tightening，normal operation，pneumatic test and hydraulic test separately are 0． 993 54，0． 993 54，0． 97260 and 0． 7925; the permissible reliabilities for tensile strength of bolts are separately 0． 999 999 991 40， 0. 999 999 991 40，0． 999 999 991 40 and 0． 999 990 226; ②minimum of safety factors for yield and tensile strengths are separately 1． 50 and 2． 10． Key words: pressure vessel; gasket sealing;