智能家具 Home Automation.docVIP

HA Manual ACRONYMS AND ABBREVIATIONS ACRONYMS ACE Ancillary Control Equipment APS Application Support Sub-layer CIE Control and Indicating Equipment HA Home Automation IAS Intruder Alarm Systems WD Warning Device ZCL ZigBee Cluster Library SAS Startup Attribute Set Start Up Parameters Short Address: 0xFFFF E PANiD: 0x0000000000000000 PAN ID: 0xFFFF Channel Mask All channels in frequency band. If needed, the power transmitted by the device on channel 26 can be lowered to comply with FCC regulations. Protocol Version 0x02 (ZigBee Specification revision 17 (2007) and later). Stack Profile 1 (ZigBee Feature Set) or 2 (ZigBee PRO Feature Set). Startup Control 3 (three) if un-commissioned, so it will join network by association when join command is indicated by button press sequence. 0 (Zero) if commissioned. Indicates that the device should consider itself a part of the network indicated by the ExtendedPANId attribute. In this case it will not perform any explicit join or rejoin operation. Trust Center Address 0x0000. Master Key NULL Network Key NULL. Default Trust Center Link Key 0x5A 0x69 0x67 0x42 0x65 0x65 0x41 0x6C 0x6C 0x69 0x61 0x6E 0x63 0x65 0x30 0x39 Note: The Link Key is listed in little-endian format. Use Insecure Join 0x01 (True). This flag enables the use of insecure join as a fallback case at startup time. Join Parameters ScanAttempts At boot time or when instructed to join a network, the device should make up to three (3) scan attempts to find a ZigBee Coordinator or Router to associate with. If it has not been commissioned, this means that when the user presses a button or uses another methodology to get it to join a network, it will scan through all of the channels up to three times to find a network that allows joining. If it has already been commissioned, it should scan up to three times to find its old network to join. TimeBetweenScans (1 second) Determines the number of seconds between each unsuccessful scan attempt Network Rej