聚氯乙烯排水管毕业设计.docVIP

摘 要 本设计从的发展现状手，生产厂实际情况，国家的政策法规，了设计原则。遵守国家法律法规，国内，国外引进的设备工艺吃透和消化，力求先进生产技术，合理经济，可行实施，可靠安全，污染环境，生态平衡保护。 ：从(AM)单体的工艺设计工段到研磨筛分工段的工艺设计（初步）。选择了溶液法制备，通过物料热量衡算，得到了物料平衡图，为设备工艺计算奠定基础。对装置组成生产方法进行了分析，了合理的操作规程工艺参数。 从A溶液配制工段到研磨筛分工段，按照物料走向，依次对配制罐、聚合釜、搅拌系统、水解机、干燥系统做物料及热量平衡计算。物料热量衡算的数据，进行了部分的工艺设计。根据设计要求，计算出罐3.3m，筒体高度4.95m。 工艺流程控制方案，出控制点的；编制了×107千克/年聚丙烯酰胺生产车间工艺设计说明书。经过最后核算，×107千克/年聚丙烯酰胺生产车间工艺设计符合设计要求，各项参数均已达标。 关键词：聚丙烯酰胺罐；工艺设计Abstract The design from the development process and the current status of polyacryla- mide approach, in the light of the actual situation of production plants, in accordance with national policies and regulations to determine the design principles: compliance with relevant state laws and regulations, based on domestic, understand and assimilate imported equipment and technology to the production of advanced technology, economic rationality, the implementation of viable, safe, reliable, and the prevention of environmental pollution, the protection of ecological balance.  According to the book design to determine the scope of design: from the Preparation of process design can AM and DMDAAC Section to the grinding section of the process design (preliminary). And select the solution method to get together polyacrylamide. Through the material and heat balance, material balance plans has been to lay the foundation for computing equipment. And production methods, devices composed of an analysis to determine the reasonable process parameters and procedures From AM Solution prepared section to the grinding section, in accordance with the material move towards, in order for the preparation of cans, polymerization autoclave, stirring system, hydrolysis machine, drying system to do the calculation of materials and heat balance. Use of material balance and heat balance data for the preparation of the thematic part of the process tank design. According to design requirements, Middle tank volume is calculated 45.468m3, diameter is 3.3m,height is 4.95m.  In accor