Part 20 - Engine Vibration SACST 培训教材.pdf

Part 20 - Engine Vibration Preparation 1) Under “Training Project”, create “Engine Vibration” subdirectory 2) Under “Engine Vibration”, Create “Modes” and “Vibration” subdirectories. 3) Copy SACINP.STA model file from “\Spectral Earthquake\Static SE” directory to “Modes” directory and rename to SACINP.ENGVIB. Modifying model file to suit engine vibration analysis 1) Delete part of substructure so only one bay of jacket left for engine vibration analysis Delete joint 3000 and its attached members. Fix the joint from 301L/301P to 307L/307P. 2) Add support for engine and compressor Add compressor joint 1000 at X = 0.0, Y = 7.0, Z = 25.25 m, joint fixity = 222222; Add engine joint 3000 at X = -5.0, Y = 7.0, Z = 25.50 m, joint fixity = 222222; Add shaft connecting joint 2000 at X = -1.75, Y = 7.0, Z = 25.25 m, joint fixity = 222222; Add compressor support member by connecting joint 1000 to 8007, 8011, 8012 and 8008, member group label CMP. Add engine support member by connecting joint 3000 to 805L, 8007, 8008 and 8004, member group label ENG. Add axial shaft by connecting joint 3000 to 2000 and 2000 to 1000, member group label SHF. Defining member properties of CMP, ENG and SHF as follows, GRUP CMP 60.960 5.080 20.00 8.0024.80 9 1.001.00 0.50N1.0E-4 GRUP ENG 60.960 5.080 20.00 8.0024.80 9 1.001.00 0.50N1.0E-4 GRUP SHF 21.907 1.270 20.00 8.0024.80 9 1.001.00 0.50N 7.849 Mode extraction under “Modes” directory, 1) Copy Seastate SEAINP.DYN file from “\Spectral Earthquake\Modes” directory to “Modes” directory. Delete member group overrides for LG1, LG2 and PL1, PL2. 2) Create Dynpac run file “Extract