Taking the Mystery Out of High Speed Modeling英文文献.pdfVIP

Taking the Mystery Out of High Speed Modeling Boundary Setup w 2D vs. 3D Metal w 3D metal properties are defined in the material setup w 2D metal properties are defined in the boundary setup w 2D metal definition is recommended if skin depth and edge coupling are not major concerns w Perfect E vs. Finite Conductivity Boundary Definitions w HFSS uses less RAM and time to solve problems with perfect E metal definitions w Perfect E boundary consists of real matrices instead of complex ones w Add metal losses at the end of simulation for accurate loss calculation Boundary Setup (cont.) w Radiation Boundary vs. PML w Recommended spacing for radiation boundary is lamda/4 while for PML, it is lamda/6. w In general, PML boundaries can be placed closer to the structure w Depending on the angle of incidence, some reflections will exist for radiation boundaries w PML boundaries have zero reflections w Radiation boundaries is a boundary condition w Definition is the 2nd order boundary condition that approximates free-space w PML is part of the solution space w Definition is a set of “fictitious” biaxial anisotropic material Source Setup – Wave Port w Traditional ports must be planar w Traditional ports must have material properties of metal on one side of its surface w Port size must be made large enough to includ