电阻率测量瑞典南部的Enemossen尾矿坝的安全评价.docVIP

Using resistivity measurements for dam safety evaluation at Enemossen tailings dam in Southern Sweden Internal erosion is a major Reason for embankment dam failures. Resistivity measurements is an essentially non-destructive technique, which may have the possibility of detecting internal erosion processes and anomalous seepage at an early stage before the safety of. The dam is at stake. This paper presents results from part of a dam Safety investigation conducted at the Enemossen tailings dam in southern Sweden. Longitudinal resistivity sections, 2D measurements along the dam crest, provided an overview of the whole dam and served to detect Anomalous zones. In selected areas, additional cross-sectional 2D surveys gave detailed information about the geoelectrical situations in the embankments. This information is valuable for similar investigations as information about resistivity in embankment construction material is scarce. Known problem areas were associated with low resistivities, even though the resistivity measurements alone did not provide enough information to confidently come to a decision about the status of the dams. Embankment dams are made of earth or rock. Internal erosion is one of the major causes of embankment dam failures. Resistivity measurements may have the possibility of detecting internal erosion processes and Anomalous seepage at an early stage before the safety of the dam is at stake. The technique is essentially non-destructive, which is particularly important when working with embankment dams where drilling and other penetrating investigations are preferably avoided. This paper presents results from part of a dam safety investigation conducted at the Enemossen tailings dam in southern Sweden. Tailings dams are a type of Embankment dam that impounds mining waste. The mining waste, which consists of ?ne-grained waste materials left after mechanical or chemical separation of minerals from crushed ore, is typically pumped into a storage reserv