ccna1_7测试真题.docVIP

1 窗体顶端 Which three factors should be considered when implementing a Layer 2 protocol in a network? (Choose three.) the Layer 3 protocol selected the geographic scope of the network the PDU defined by the transport layer the physical layer implementation the number of hosts to be interconnected 窗体底端 2 窗体顶端 Refer to the exhibit. A frame is being sent from the PC to the laptop. Which source MAC and IP addresses will be included in the frame as it leaves RouterB? (Choose two.) source MAC - PC source MAC - S0/0 on RouterA source MAC - Fa0/1 on RouterB source IP - PC source IP - S0/0 on RouterA source IP - Fa0/1 of RouterB 窗体底端 3 窗体顶端 What is the primary purpose of the trailer in a data link layer frame? define the logical topology provide media access control support frame error detection carry routing information for the frame 窗体底端 4 窗体顶端 What is true concerning physical and logical topologies? The logical topology is always the same as the physical topology. Physical topologies are concerned with how a network transfers frames. Physical signal paths are defined by Data Link layer protocols. Logical topologies consist of virtual connections between nodes. 窗体底端 5 窗体顶端 What determines the method of media access control? (Choose two.) network layer addressing media sharing application processes logical topology intermediary device function 窗体底端 6 窗体顶端 What is the purpose of the preamble in an Ethernet frame? is used as a pad for data identifies the source address identifies the destination address marks the end of timing information is used for timing synchronization with alternating patterns of ones and zeros 窗体底端 7 窗体顶端 Which statements describe the logical token-passing topology? (Choose two.) Network usage is on a first come, first serve basis. Computers are allowed to transmit data only when they possess a token. Data from a host is received by all other hosts. Electronic tokens are passed sequentially to each other. Token passing net