毕业设计说明资料多工位级进模具的设计.doc

毕业设计说明书 “限位盖板”零件冲压工艺与模具设计 学 院（部）： 机械工程学院 专 业： 材料成型及其控制工程 学 生 姓 名： 谭明来 班 级： 072班 学号 07405300237 指导教师姓名： 胡成武 职称 教授 朱亨荣 职称 讲师 最终评定成绩 2011年 4月 摘 要 本次设计的零件为件。采用的材料，厚度具有足够的强度刚度良好的塑性,可首先对零件进行了工艺性分析，有、、、落料等一系列工序，各工位有相互的尺寸关系，采用普通的单工序模或复合模多工位级进模，可提高材料的利用率。经过计算分析完成该模具的，凸、凹模工作部分的设计计算，还有和零件设计，选择合适的模具材料。 级进模，，ABSTRACT The mold designing the parts to cut deep down—Wide range of application of Limit potential blind patch。 The material is H62(M), Thickness: 0.5mm, This material resistant to corrosion, electricity, the better for the performance is often used for manufacturing and electronics ； parts of the material have sufficient strength and stiffness and a plastic, but deep cut and ran to the processing. First has carried on the technological analysis to the components, has the multiple drawing, the reshaping, the punch holes, and falls the material and so on a series of working procedures, various locations have the mutual size relations, and the size and the position accuracy requirement is high, if uses the ordinary single working procedure mold or the compound plunger production needs many vice-molds, many punch presses, many operators only then to be able to complete all working procedures the ramming process of manufacture, moreover the product quality could not obtain the very good guarantee, the production efficiency is relatively low. Therefore selects the multi-location level to enter the technique of production which the mold processes, may enhance the material the use factor, to raise the production efficiency greatly, and can achieve the energy conservation environmental protection. Secondly has been computinged the row kind that the analytical assurance craft scheme completes the molding tool design, convex, the design computing of the cave mold operate fraction, there is also