所需工具WireCutter线切割机WireStripper剥线钳PhillipsScrew.PDFVIP

Panel Lyte Sample Production Manual Complete integrated LED lighting solutionsTM Written Instructions 面板灯样品生产手册 Tools Needed: 所需工具 Wire Cutter 线切割机 Wire Stripper 剥线钳 Phillips Screw Driver 螺 丝刀 Adjustable Wrench 扳手 Wrench 22mm for PG9 Wrench 24mm for PG11 Drill Bit : 16mm for PG9 22mm的是PG9扳手，24mm的是PG11钻头扳手，16mm的是PG9 Drill Bit : 19mm For PG11 钻头：19mm是PG11 Parts Needed: 所需零件 2 meters of 6 Conductor Wire 6条2米的导线 7 Orange Wire Nuts 7个橙色线螺母 0-10 Controller 0-10控制器 2 PG11 Cord Grips 2个PG11线夹 1 PH9 Cord Grip 1个PH9线夹 4 Hex Nuts (Size TBD - Need part #) 4个螺母（尺寸待定，需要型号） Page 1 of 23 Panel Lyte Sample Production Manual TM Written Instructions Complete integrated LED lighting solutions 面板灯样品生产手册 1. Wire Prep 电线准备 1. Cut 6 Conductor Wire to 2 meters 将6根导线剪成2米一根 2. Strip Ends 剥去末端 a. Side A : Strip Black housing to 125mm A端: 剥去黑色外罩125mm b. Side B : Strip Black housing to 50mm B端：剥去黑色外罩50mm 3. Remove Clear Plastic Cover 拆下透明塑料盖 4. Strip all wires 12mm 每根电线剥12mm 5. Remove Yellow Wire and Keep Side A scrap 拆下黄色电线并保存为A端的一块废料 a. Strip both sides of longer yellow wire to 12mm 将黄线两端都剥去12mm 6. Discard of Side B Yellow Wire. 丢弃B端的黄线 7. Discard of middle core 丢弃中间核心 2. Panel Prep 面板准备 1. Remove Screws from Driver Enclosure 从电源外壳上拆除螺钉 2. Remove Front Knock out 拆下前面的孔盖 3. Install Large Grommet + Washer assembly 安装大垫圈及垫圈组件 4. Insert Side A of 2 meter Cable 插入A端2米的电缆 5. Wire 0-10 0-10 电线 a. W