第3部分准备网络环境磁盘和yum源-Lunar的oracle试验室.PDFVIP

Lunar() 使用VBox 安装 Oracle Database 12c Flex Cluster for OEL 5.8 第3 部分 准备网络环境 （磁盘和yum 源） 本系列为Lunar()原创，一共5 篇，分别为： 第1 部分 环境介绍 第2 部分 前期准备工作 第3 部分 准备网络环境 第4 部分 开始安装 第5 部分 总结 先看下官方文档，以下是相关需求： Check Task Public Network Hardware : • Public network switch (redundant switches recommended) connected to a public gateway and to the public interface ports for each cluster member node. • Ethernet interface card (redundant network cards recommended, bonded as one Ethernet port name). • The switches and network interfaces must be at least 1 GbE. • The network protocol is TCP/IP. Private Network Hardware for the Interconnect • Private dedicated network switches (redundant switches recommended), connected to the private interface ports for each cluster member node. NOTE: If you have more than one private network interface card for each server, then Oracle Clusterware automatically associates these interfaces for the private network using Grid Interprocess Communication (GIPC) and Grid Infrastructure Redundant Interconnect, also known as Cluster High Availability IP (HAIP). • The switches and network interface adapters must be at least 1 GbE. • The interconnect must support the user datagram protocol (UDP). Oracle Flex ASM Network Hardware Oracle Flex ASM can use either the same private networks as Oracle Clusterware, or use its own dedicated private networks. Each network can be classified PUBLIC or PRIVATE+ASM Lunar() Check Task or PRIVATE or ASM. ASM networks use the TCP protocol. Cluster Names and Addresses : Determine and Configure the following names and addresses for the cluster • Cluster name : Decide a name for the cluster, and be prep