关于EI检索长短号的描述.doc

Accession number:Title: Design of the miniature optical fiber voltage sensorAuthors: Jun Liu1 ; Guoqing Jiang1 ; Shubin Yan1 ; Shaohui Wang1 ; Yingzhan Yan1 ; Yanfeng Jing1 ; Jijun Xiong1 ;Xiongying Ye; Zhaoying Zhou; Wendong Zhang1Author affiliation: 1 Nat. Key Lab. For Electron. Meas. Technol., North Univ. of China, Taiyuan, ChinaSource: 2009 4th IEEE International Conference on Nano/Micro Engineered and Molecular Systems (IEEENEMS2009)Publication date: 2009Pages: 1008-12Language: EnglishISBN-13: 978-1-4244-4629-2Document type: Conference article (CA)Conference name: 2009 4th IEEE International Conference on Nano/Micro Engineered and Molecular Systems (IEEENEMS2009)Conference date: 5-8 Jan. 2009Conference location: Shenzhen, ChinaSponsor: IEEEPublisher: IEEEPlace of publication: Piscataway, NJ, USAMaterial Identity Number: YXA9-1901-011Abstract: Based on the typical microcavity quantum property and integration of the planar microtoroid withultra-high Q value(about 108), this paper theoretically proposes the design of the micro-opticalvoltage sensor. The voltage sensor belongs to the field of MOEMS, the entire device is composedof one microtoroid (diameter from 60 μm to 120 μm) with the ohmic contact in the middle and a fibertaper waveguide. Through contact dot the outside detected voltage is connected with the ohmiccontact, as a result of the ohmic contact heat effect, the external voltage signal through the devicetransforms into a strong frequency shift which is coupled out through the fiber taper waveguide.After that it will be showed on the photoelectric detector and then the voltage value under test couldbe calculated.Number of references: 23Inspec controlled terms: fibre optic sensors - ohmic contacts - optical waveguidesUncontrolled terms: optical fiber voltage sensor - micro-optical voltage sensor - ohmic contact - contact dot - photoelectricdetectorInspec classificationcodes:A4281P Fibre optic sensors; fibre gyro