NYZ402-494-02-12SY机舱行车系泊试验程序.docVIP

TECHNI CAL DATA M/E Crane Maker : JIANGYIN CHENGJIANG Type : CQC4-5.4-15SD Hoisting weight : 4000kg Span : 5.40 m Height of lift : 15 m Hoisting speed : 9/0.9m/min Longitudinal length : 16.52m Longitudinal speed : ~6m/min Transversal speed : ~6m/min Power supply : 440V, 60Hz Hoisting motor Type : CZDM1 9/0.9kW Traveling motor Type : CZDY1-12 0.4kW? PREFERENCE DOCUMENTS CHENGJIANG Instruction manual TEST PROCEDURE Test condition The shop test will be practiced by the horizontal bench. The rail length for traveling is not less than 3.5m.On-board test will be not carried out beyond heeling 5 篴nd trim 2? m.车间试验应在水平试验台上进行，行走导轨长度不少于3.5米，船上试验不能倾斜超过5 o配平超过2o The following tests will be practiced; and it will be ascertained whether each part of the crane moves normally. 下列试验应执行，确定是否行车的各部件是否正常行走。 No-load test Transverse framing test, it will confirm transverse framing moving normally or not. Transverse framing to go and back shall be not less once. 横向行走架试验，确认行车横向行走架行走是否正常，横向往返行走不少于1次。 Longitudinal framing test, it will confirm longitudinal framing normally moving or not. 纵向行走架试验，确认纵向行走架行走是否正常。 Hoisting test提升试验 This test will be practiced at normal speed and lower speed so that ascertain the whole movement is smooth. Hoisting speed, voltage and current of electric motor will be satisfied with relevant requirements. It is required that the brake can work smoothly in any location. 试验以正常和稍低的速度运行，以确认整个运行平稳。提升速度、电机电压和电流都要满足要求。要求刹车能在任何位置平稳运行。 Load test 负荷试验 Lifting test 起重试验 Lifting 50% and 100% rated load, hoisting speed, voltage and current of electric motor shall be according to requirements. 以50%和100%的负荷进行起重试验，提升速度、电机电压和电流应满足要求。 Longitudinal moving test of girder frame, made reference records(running spee