3rd edition, chapter 5 - duke university文档.pptVIP

* * * * * * * * * * * 5: DataLink Layer ATM cell header VCI: virtual channel ID will change from link to link thru net PT: Payload type (e.g. RM cell versus data cell) CLP: Cell Loss Priority bit CLP = 1 implies low priority cell, can be discarded if congestion HEC: Header Error Checksum cyclic redundancy check 5: DataLink Layer IP-Over-ATM Classic IP only 3 “networks” (e.g., LAN segments) MAC (802.3) and IP addresses IP over ATM replace “network” (e.g., LAN segment) with ATM network ATM addresses, IP addresses ATM network Ethernet LANs Ethernet LANs 5: DataLink Layer IP-Over-ATM AAL ATM phy phy Eth IP ATM phy ATM phy app transport IP AAL ATM phy app transport IP Eth phy 5: DataLink Layer Datagram Journey in IP-over-ATM Network at Source Host: IP layer maps between IP, ATM dest address (using ARP) passes datagram to AAL5 AAL5 encapsulates data, segments cells, passes to ATM layer ATM network: moves cell along VC to destination at Destination Host: AAL5 reassembles cells into original datagram if CRC OK, datagram is passed to IP 5: DataLink Layer IP-Over-ATM Issues: IP datagrams into ATM AAL5 PDUs from IP addresses to ATM addresses just like IP addresses to 802.3 MAC addresses! ATM network Ethernet LANs 5: DataLink Layer Multiprotocol label switching (MPLS) initial goal: speed up IP forwarding by using fixed length label (instead of IP address) to do forwarding borrowing ideas from Virtual Circuit (VC) approach but IP datagram still keeps IP address! PPP or Ethernet header IP header remainder of link-layer frame MPLS header label Exp S TTL 20 3 1 5 5: DataLink Layer MPLS capable routers a.k.a. label-switched router forwards packets to outgoing interface based only on label value (don’t inspect IP address) MPLS forwarding table distinct from IP forwarding tables signaling protocol needed to set up forwarding RSVP-TE forwarding possible along paths that IP alone would not allow (e.g., source-specific routing) !! use MPLS for traffic engineering must co-exis