pcf8591英文毕设.docVIP

8-bit A/D and D/A converter PCF8591 1. FEATURES . Single power supply . Operating supply voltage 2.5V to 6.0V . Low standby current . Serial input/output via I2C-bus . Address by 3 hardware address pins . Sampling rate given by I2C-bus speed .4 analog inputs programmable as single-ended or different inputs . Auto-incremented channel selection . Analog voltage range from VSS to VDD . On-chip track and hold circuit . 8-bit successive approximation A/D conversion . Multiplying DAC with one analog output 2. APPLICATION . Closed loop control systems . Low power converter for remote data acquisition 3. GENERAL DESCRIPTION The PCF8591 is a single-chip, single-supply low power 8-bit COMS data acquisition device with four analog inputs, one analog output, and a serial I2C-bus interface. Three address pins AD, A1 and A2 are used for programming the hardware address, allowing the use up to 8 devices connected to the I2C-bus without additional hardware. Address, control and data to and from the device are transferred serially via the two-line bidirectional I2C-bus. The functions of the devices include input Multiplexing, on-chip track and hold function, 8-bit analog-to-digital conversion and an 8-bit digital-to-analog conversion .the maximum conversion rare is given by the maximum speed of the I2C-bus. 4. ORDERING INFORMATION TYPE NUMBER PACKAGE NAME DESCRIPTION VERSION PCF8591P DIP16 Plastic dual in-line package,16 leads SOT38-4 PCF8591T SO16 Plastic small outline package,16 leads SOT162-1 7. FUNCTION DESCRIPTION 7.1 Each PCF8591 device in an I2C-bus system is activated by sending a valid address to the device .The address consists of a fixed part and a programmable part. The programmable part must be sent according to the address pins A0, A1 and A2. The address always has to be sent as the first byte after the start condition in the I2C-bus protocol. The last bit of the address byte is the read/write-bit which sets the direction of the following da