td-scdmadtx介绍.pptVIP

COM TD training TD-SCDMA DTX TEST INTRODUCTION Issued by Jin Shu Xin Overview What‘s DTX Discontinuous transmission (DTX) is a technique that basically suspends any signal transmission during service(CSPS) pauses, which had been specified in GSM The benefits: mobile terminal battery saving reduction of on-air interference thus improvements in system capacity and reduction of interference What’s DTX When there has no data from high layers then a special burst (SB) should be transmitted in the first allocated frame of pause If, including the first frame, there is a consecutive period of Special Burst Period (SBP) frames without transport blocks provided by higher layers, then Another special burst generated and transmitted at the next possible frame. Patterns continued until there has data from high layer SBP is signalled by high layer TFCI for SB is configured to be zero, data part bits for SB can be arbitrary TPC bits can be applied to keep the inner loop power control Data Block 1 Data Block 2: 352 chips Midamble: 144 chips, Guard period: 16 chips Power Control Types Open Loop Power Control Used for UL transmission to control the initial transmission power (e.g., for random access) of UE based on attenuation of the transmission power of the NodeB Inner Loop Power Control NodeB or UE compare the received power with a specified SIR threshold, and issue corresponded Transmit Power Control (TPC), i.e., “Up”, “Down” Outer Loop Power Control SIR threshold can be determined by RNC by the reports from NoedB or UE Power Control Types BERBLERSIRRSCP Downlink DTX Mode General Downlink DTX Mode General Uplink DTX Mode General Uplink DTX Mode General The RNC should be able to support the message “uplink physical channel control(UL_PH_CH_CTRL)” in Uu interface for UL DTX. Parameters set though LMT-R SET: RNCCORRMSOFTPARAS=RNCCORRMSOFTPARAS:0, CORRMSOFTPARAINDEX=16, CORRMSOFTPARA=1 The RNC should be able to ch