轴端盖罩冷冲压工艺及模具设计论文（机械CAD图纸）.docVIP

摘 要 冲压生产是一种先进的金属加工方法。它是利用模具和冲压设备对板材金属进行加工，通过冲压生产可以获得所属要的零件形状和尺寸。本课题是零件的冲压模具的设计根据设计零件的尺寸、材料、生产批量等要求，分析零件的工艺性，确定冲裁工艺路线方案，从而设计一套复合模具，在保证工件的尺寸和形状位置精度要求的同时，尽量的提高材料的利用率和生产效率。随着计算机技术的不断发展，采用CAD/CAE/CAM一体化技术可以准确、快速的完成模具设计制造。本文主要是介绍说明零件成形的各个工序及其模具的设计及尺寸计算，在结构设计的同时，对主要零件的设计和装配要求技术进行了分析。设计时考虑到模具设计合理、简单，便于制造和修模，有利于缩短模具生产制造周期，降低成本。 关键词：零件；；复合模；模具设计 Abstract Stamping production is a kind of advanced metal processing method. It is the use of mould and stamping equipment to carry on the processing of sheet metal. Through stamping production, we can get the shape and size of the parts which we need. This topic is about the design of the stamping mould for the shaft end cover parts. According to requirements of part size, material, production batch, etc. we should analyze the manufacturability of parts, and determine a medium manufacture route to design a set of compound mould. The mould selection of deep drawing technology is a simple quadratic model, considering the shape of the stamping characteristics, size, accuracy and stamping equipment and molding conditions, convenient operation and safety. Mold 1: blanking deep drawing die and mould 2: the second drawing die, first deputy die blanking, deep drawing composite modulus is discharging structure of elastic unloading (spring), artifacts using push a piece of rigid, launch mechanism mounted on the upper die, blank holder device installed in mold parts, the structure of elastic (spring), and push up a role as well. Manual feeding device for the strip material, article sample between artifacts and artifact and between the material side of excess stock is called on. On the position error compensation, ensure rushed out of the qualified parts. Can also make the strip material has certain rigidity, easy to into. As the first vice mould is blanking, deep drawing composite modulus, just consider the layout of blanking, the single straight line method is adopted.We not only should ensure the size and shape of the workpiece position accur