主板的驱动安装与调试.doc

installing and debugging engraving system One Install mainboard driver This kind of mainboard uses the USB port and the computer connection, transmits the data. Before the it useing, must install the driver Method of Installing: Starts the computer first, turns on the carving machine power, then connects with the USB ties the computer and the mainboard, by now on the computer screen could appear discovers the new hardware... ... etc, sees photo F2-18: F2-18 Please put the application which one is allocated stochastically into CD-ROM, a few minutes later it will appear like the F2-19 dialog box: F2-19 Single-clicks next step, can appear like as the F2-20 interface: F2-20 Selects assigns a position, namely in its front gets √, single-clicks next step: Appears like as the F2-21 interface: F2-21 System will request designation the path of driver here , single-clicks the browsing (B) with the mouse, appears like as the F2-22 interface: F2-22 Attention: different computer plate symbol is possibly dissimilar, up chart the compact disc is the G plate, but not all computers compact disc are the G plate, please determine the compact disc in right plate. F2-23 In chart F2-23, please choose the folder namedusb-driver, single-clicks opens (0) with the mouse, sees chart F2-24: F2-24 In chart F2-24, Single-clicks opens (O), can see the F2-25 information F2-25 Single-clicks next step (N), computer will install automatically, after the installment completes, the screen can appear as the F2-26 information: F2-26 Single-clicks finish button, finished the equipment driver installing. Restarts the computer and put the mouse on my computer to single-click the right key, find out the attribute, choose the hardware in equipment manager ,examine the port (com and plt), then you can see the driver information usb serial port com3, indicated the carv