增压器结构原理精品.pptVIP

* Read from Slide * Before showing this slide, check with the audience that they have some appreciation of the speeds that our rotors rotate. Use a flip and writ down the 3 model types then ask the attendees to shout out what they think is the running speed of each one. H1C/HX35 140,000rpm H1E/HX40 180,000rpm H2/HX60 116,000rpm Then read slide. * Impeller and turbine wheel are rotated and checked for out of balance force. Out of balance corrected by material removal. On the turbine wheel material is removed from the boss (or nose), the backface and the blade edge. * On the impeller, the material is removed from the boss (or nose) the outer diameter and in some cases the back face. * Assemble the turbine, impeller, oil slinger and thrust washer. Tighten the locknut to the recommended service torque. * Rotate the rotor on the balancing machine and check out-of-balance forces against service tolerance. If the rotor is not in balance, change the position (attitude) of the impeller.(in 90deg stages) Re-check the balance to ensure it is within service tolerance. * Rotate the rotor on the balancing machine and check out-of-balance forces against service tolerance. If the rotor is not in balance, change the position (attitude) of the impeller.(in 90deg stages) Re-check the balance to ensure it is within service tolerance. * Handout time. Explain that this dial shows the results of 5 sample Turbine Wheels. Read from hand out and allow 10 / 15 minutes for attendees to complete the form. Then use the flip chart to confirm findings and discuss. also mention other types of balancing machines if you know about them. * Mark all components to ensure correct reassemble in the CHRA. If the rotor does not come into balance:- Try different combinations of thrust parts. Change the impeller. Do not cut metal to bring the rotor into balance. * * * * * * To increase the power from your engine you could: Add more fuel Increase the size of the engine (swept