Engineering Circuit Analysis, Sixth Edition - Welcome to …：工程电路分析，第六版-欢迎…[精品].doc

Engineering Circuit Analysis, Sixth Edition W.H. Hayt, Jr., J.E. Kemmerly, and S.M. Durbin Errata Chapter 3: Voltage and Current Laws 10 Oct 2002 p. 60: The right-most current source of Fig. 3.71b should be labelled 3.5 A. Chapter 4: Basic Nodal and Mesh Analysis 10 Oct 2002 p. 76: In Figure 4.4, the left-most node should be labelled v1, not v-1. Chapter 5: Useful Circuit Analysis Techniques 10 Oct 2002 p. 122: In Figure 5.30b, the voltage across the 1-A source should be labelled vtest. p. 132: In Figure 5.47, the current through the 20-? resistor should be labelled I1 (not i1), for the sake of consistency. p. 134: In Fig. 5.55, a DC voltage source symbol should be used for the 2-V source. (Delete the “~”). p. 139: The circuit discussed in exercise 45 is actually a common-collector transistor amplifier, not a common-emitter amplifer as stated. p. 145: Exercise 68 should read: The human ear can detect sound waves in the frequency range of about 20 Hz to 20 kHz. If each 8-? resistor in Fig. 5.102 is a loudspeaker, which of the signal generators (modeled as practical voltage sources) produces the most sound? (Take “loudness” as proportional to power delivered to a speaker.) Chapter 6: The Operational Amplifer 10 Oct 2002 p. 157: The solution to Practice 6.3 is -ARiRf / [RiRf + R1Rf + (1 + A)R1Ri] p. 165: In Figure 6.28, the sinusoidal source should be labelled 2sin3t V, not 2sin3t mV. p. 169: Figure 6.42, corrected circuit diagram p. 170: In exercise 38, use an LF411 instead of an LM 324. Chapter 7: Capacitors and Inductors 10 Oct 2002 p. 177: Under Energy Storage, the upper limit of the third integral is incorrect. The correct integral expression is: p. 186: Under Energy Storage, the second integral is missing a term. The correct expression should read: p. 199: In the solution to Practice 7.8, the second answer should have units of mV. p. 203: In Figure 7.40