4000㎡快捷酒店设计土木工程快捷酒店设计计算书推荐.doc

PAGE 本科生毕业论文(设计) 4000㎡快捷酒店设计 　　　　　　　　　 摘 要 快捷酒店设计，批准的建筑面积为4000㎡左右， 建筑主体为5层，首层层高4.25m，标准层层高3.3m，总建筑高度17.45m。拟采用钢筋混凝土框架结构，楼板与楼盖采用全现浇形式。借鉴以往的快捷酒店设计资料、 现行的国家和地方的法规和规范， 结合指导老师的指导，根据当地的现有情况满足该课题的各项要求。在充分理解快捷酒店设计任务要求的基础上，使建筑设计达到房间设置合理、使用方便、设计方法正确、步骤清晰完整。设计过程中，准备阶段主要工作为：收集必要的设计原始资料，做好设计前的调查研究工作，参考同类型设计的文字及图纸资料；学习有关的国家法律法规及规范，建筑设计的依据性文件等。 本设计的主要内容包括快捷酒店的建筑方案设计和结构计算。其中结构设计计算是重点。采用手算进行空间结构计算分析，并采用一榀框架计算框架进行计算。其计算内容主要有：竖向荷载和风荷载、水平地震作用计算，各种荷载作用下框架内力分析及水平荷载作用下框架侧移验算，内力组合及框架梁、框架柱配工程筋计算，楼板配筋计算，楼梯和基础设计计算等。 关键词 钢筋混凝土框架结构；内力组合；配筋计算；柱下独立基础； Abstract Quick hotel design, approved construction area of 4000 ㎡ or so, building subject for 5 layers, layers of the first high 4.25 m, 3.3 m high standard layer upon layer, the total construction height of 17.45 m. Is used to steel reinforced concrete frame structure, floor and floor adopts full cast-in-situ form. Referencing past quick hotel design material, the current national and local laws and regulations and standard, and union guide teachers guidance, according to local conditions meet existing the subject to requirements. Full understanding of hotel in quick design task requires the basis of architectural design room to set reasonable, use convenient, design method correctly, steps are clear and complete. In the process of design, preparation for the main job is to: gather the necessary design original material, well before the design of the investigation and research, reference type design with words and drawings; Learn about the state laws and regulations and the standard, architectural design basis file etc.. The main content of this design including shortcut hotel architecture design and structure calculation. Structure design of calculation is the key. By hand space structure calculation is analyzed, and a hinged frame by frame calculation is calculated. The calculation for main: vertical load and wind load, horizontal seismic calculation, all kinds of load force analysis framework and the horizontal load framework lateral li