神龙矿区立井井筒设计和施工组织方案设计推荐.docVIP

摘 要 本设计的主要目的是介绍神龙矿区立井井筒设计和施工组织方案设计。设计内容一共分为五章，分别为： 第一章主要介绍国内立井井筒施工的发展历程，包括：设计理念的形成、实践，在我国的引进发展，和对更深层次设计思想的探索等。 第二章主要介绍神龙矿的工程概况，水文地质概况，和主井的主要技术参数，为而后的设计提供必要的数据储备。 第三章是立井的井壁设计，主要包括：设计依据，井壁结构的选择，井壁荷载，井壁厚度的设计计算，可缩装置的设计计算，配筋计算等。冻结壁厚度的计算，采用多姆克强度理论和经验公式计算结果的平均值，来比较得到。冻结壁平均温度的计算,由于岩体平均温度计算公式是适用在单排管冻结下的，而实际主井的冻结方案是三排管的差异冻结，因此最后的计算平均温度与实际设计平均温度有出入。 第四章是井筒的强度验算，主要包括内外壁的强度验算和配筋验算。 第五章是总结，包括毕设设计和致谢。 关键词：立井；施工；井壁；方案设计 Abstract Summary of the main purpose of the project is to introduce the shenlong mine shaft design and construction organization design. Design content is divided into five chapters in total, are as follows: Chapter I focuses on mine shaft construction in Chinas development process, including: design concept formation, practice, introduction of development in China, and for deeper exploration of design ideas. Chapter II focuses on project overview of the shenlong mine, hydrological and geological survey, and main technical parameters, and designed to provide the necessary data of the reserve. Chapter III is the design of shaft lining, including: design considerations, selection of shaft lining structure and wall loads, design and calculation of wall thickness, shrinking device design, reinforcement calculation, and so on. Calculation of thickness of frozen wall, with Sam gram strength theory and empirical formula calculation results, on average, to be. Calculation of average temperature of frozen wall, due to the average temperature of rock formula is applicable under the single pipe freezing, but the actual difference programme is three main shaft freezing pipe freezing, so the final calculation of average temperature and average temperature different from actual design. The fourth chapter is a strength check of the shaft, including intensity checking computation and reinforcement calculation of the inner and outer walls. The fifth chapter is summarized, including set design, and thanks. Keywords: Vertical shaft；Construction；Shaft lining；Sheme design 目录