ppap motorola training(ppap摩托罗拉培训资料).pptVIP

By: Zubair Iqbal By: Zubair Iqbal The intent of this training is to communicate Motorola’s, PPAP requirements to the suppliers and train the SDE Engineers and suppliers on these PPAP requirements for qualification What does PPAP stand for ?? Is Motorola changing the qualification requirements ?? Motorola is not changing qualification requirements, instead Motorola is enhancing/adding the current qualification requirements to match the PPAP requirements. (1) Design Records (2) Engineering Change Documents (if any) (3) Customer Engineering Approval (If required) (4) Design FMEA (6) Process FMEA (7) Dimensional Results (8) Material, Performance Test Results Material, Performance Test Results: Material tests are test that specified on Motorola print or specifications as chemical, physical or metallurgical tests e.g. MEK, abrasion, adhesion, ……etc. Performance tests are test that specified on Motorola print or specifications as performance tests e.g. number of cycles, environmental testing, electrical testing, Plating thickness, Paint thickness, Gloss readings, ……etc. (9) Initial Process Studies (11) Qualified Laboratory Documentation (12) Control plan (13) Part Submission Warrant (14) Appearance Approval Report (15) Bulk Material Requirements Checklist (16) Sample production Parts (17) Master Sample (18) Record of Compliance With customer specific Requirements (19) Checking Aids (20) Run at Rated Speed  How many of the PPAP requirements will be required for qualification and which ones ? MOT PPAP REQUIREMENTS So as a supplier, what should I submit for qualification? Following items need to be submitted for Motorola qualification requirements. Supplier may need to submit additional requirements based on the specific commodity. Refer to your local SDE or CTE for additional requirements for a specific commodity. Design Records Process Flow Diagram Process FMEA Dimensional Results Material performance Test Results Initial Process Studies M