电子密码锁主程序.docVIP

#includereg51.h #includekey.h #include AT24C02.h #includeLCD_1602.h #define uchar unsigned char #define uint unsigned int sbit OUT2=P3^1; sbit OUT1=P3^0; sbit read_key1=P3^2; sbit read_key2=P1^3; uchar key_scan_en; uchar key_buf; //*********************************************************** //键扫描表 uchar code key_scan_tap[4]={0x10,0x20,0x40,0x80}; uchar code Led_dsp_tap[7]={0xfe,0xfd,0xfb,0xf7,0xef,0xdf,0xbf}; //键码表****************************************************** uchar code key_tap[16]= { 0x4e,0x87,0x47,0x27, 0x8b,0x4b,0x2b,0x8d, 0x4d,0x2d,0x2e,0x8e, 0x1e,0x1d,0x1b,0x17 }; uchar new_key; uchar old_key; uchar key_cont; uchar key; //******************************************** uchar input_cont; uchar input_cont2; uchar input_step; //******************************************** uchar password[6]; uchar input_password[6]; uchar input_password2[6]; char dsp_buf[6]; uchar open_en; uchar OUT_delay; uchar err_cont; uchar stop_delay; uchar set_flg; uchar input_time; struct key_flag { unsigned password_in:1; unsigned keep:1; unsigned open:1; unsigned redly_keep:1; unsigned call_open:1; unsigned ID_OK:1; unsigned control_en:1; unsigned control_input:1; } key_flag; struct key_flag2 { unsigned power_key:1; } key_flag2; //*************************************************** extern uchar sec; extern uchar beef_cont; //*************************************************** void key_control(void) { uchar i; if(set_flg==0) { if(open_en) { if((key10)(err_cont3)) { if(input_cont6) { WRITE_ML(0x01);// 清显示 dsp_buf[input_cont]=*; lcd_dsp(0,0,input password,14); lcd_dsp(1,0,password:,9); input_password[input_cont]=key; input_cont++; lcd_dsp(1,9,dsp_buf,input_cont); } } else if(key==10)//确定键 { if(input_cont==6) { for(i=0;i6;i++) { if(input_password[i]!=password[i])