AS-NZS-60745.2.4-2003.Image.Marked文档.pdfVIP

AS/NZS 60745.2.4:2003 (IEC 60745-2-4:2003, IDT) HAND-HELD MOTOR-OPERATED ELECTRIC TOOLS – SAFETY – Part 2.4: Particular requirements for sanders and polishers other than disk type (IEC 60745-2-4:2003, IDT) AS/NZS 60745.2.4:2003 This Joint Australian/New Zealand Standard was prepared by Joint Technical Committee EL/2 - Safety of household and similar electrical appliances and small power transformers. It was approved on behalf of the Council of Standards Australia on 1 September 2003 and by the Council of Standards New Zealand on 9 September 2003. It was published on 14 November 2003. The following interests are represented on Committee EL/2 Association of Certification Bodies Australian Chamber of Commerce and Industry Australian Electrical and Electronic Manufacturers Association Canterbury Manufacturers Association New Zealand Consumer Electronic Suppliers Association, Australia Electrical regulatory authorities, Australia Electrical test laboratories Electrical consultants Electricity Supply Association of Australia Institution of Engineers Australia Metal Trades Industries Association of Australia Ministry of Consumer Affairs, New Zealand Keeping Standards up-to-date Standards are living documents, which reflect progress in science, technology and systems. To maintain their currency, all Standards are periodically reviewed, and new editions are published. Between editions, amendments may be issued. Standards may also be withdrawn. It is important that readers assure themselves they are using a current Standard, which should include any amendments which may have been published since the Standard was purchased. Detailed information about joint Australian/New Zealand Standards can be found by visiting the Standar