51密码锁程序.docVIP

#includereg52.h//头文件 #includeintrins.h #define LCM_Data P0 #define uchar unsigned char #define uint unsigned int #define w 6 //定义密码位数 sbit lcd1602_rs=P3^5; sbit lcd1602_rw=P3^6; sbit lcd1602_en=P3^4; sbit Scl=P2^1; //24C02串行时钟 sbit Sda=P2^0; //24C02串行数据 sbit ALAM = P2^3; //报警 sbit KEY = P0^4; //开锁 sbit open_led=P1^7; //开锁指示灯 bit operation=0; //操作标志位 bit pass=0; //密码正确标志 bit ReInputEn=0; //重置输入充许标志 bit s3_keydown=0; //3秒按键标志位 bit key_disable=0; //锁定键盘标志 unsigned char countt0,second; //t0中断计数器,秒计数器 void Delay5Ms(void); unsigned char code a[]={0xFE,0xFD,0xFB,0xF7}; //控盘扫描控制表 unsigned char code start_line[] = {password: }; unsigned char code name[] = {Coded Management}; //显示名称 unsigned char code Correct[] = { correct }; //输入正确 unsigned char code Error[] = { error }; //输入错误 unsigned char code codepass[] = { pass }; unsigned char code LockOpen[] = { true }; //OPEN unsigned char code SetNew[] = {SetNewWordEnable}; unsigned char code Input[] = {input: }; //INPUT unsigned char code ResetOK[] = {ResetPasswordOK }; unsigned char code initword[] = {Init password...}; unsigned char code Er_try[] = {error,try again!}; unsigned char code again[] = {input again }; unsigned char InputData[6]; //输入密码暂存区 unsigned char CurrentPassword[6]={1,3,1,4,2,0}; //当前密码值 unsigned char TempPassword[6]; unsigned char N=0; //密码输入位数记数 unsigned char ErrorCont; //错误次数计数 unsigned char CorrectCont; //正确输入计数 unsigned char ReInputCont; //重新输入计数 unsigned char code initpassword[6]={1,2,3,4,5,6}; //=====================5ms延时============================== void Delay5Ms(void) { unsigned int TempCyc = 5552; while(TempCyc--); } //===================400ms延时============================== void Delay400Ms(void) { unsigned char TempCycA = 5; unsigned int TempCycB; while(TempCycA--) { TempCycB=7269; while(TempCycB--); } } //================================24C02===============================/