芬顿氧化混凝沉淀处理煤化工废水生化出水试验分析word格式论文.docxVIP

哈尔滨工业大学工程硕士学位论文 哈尔滨工业大学工程硕士学位论文 -  PAGE 4 - -  PAGE 5 - Abstract Coal-chemical engineering wastewater is a biodegradable industrial wastewater, its biochemical effluent can hardly meet the national emission standards, especially the COD and Color. Based on the characteristics of coal- chemical engineering wastewater and the investigation about the methods of advanced treatment for coal-chemical engineering wastewater, coagulation, Fenton oxidation and Fenton oxidation-coagulation were used to dispose wastewater in the advanced treatment. A suitable treatment to dispose coal-chemical engineering wastewater in an efficient and lower cost way was expected to find. The whole study was divided into three parts. First, The effluent from secondary sedimentation tank of coal-chemical engineering wastewater was treated by the coagulation system posed by the coagulant, coagulant aid and adsorbent. Based on treatment effect, the best experimental conditions of coagulation were proposed. Second, the method of Fenton oxidation treatment was studied to determine the best experimental conditions. Finally, Fenton oxidation-coagulation precipitation method was studied. The result of the first part about coagulation experiment: the best coagulation conditions of PAC show that, the dose of PAC、PAM、Powdered activated carbon is 350mg/L 、 2.0mg/L and 1.0g/L respectively, pH is 6.8~7.2 and the precipitation time is 30min, then the removal rate of COD 、 Color is 61.62% and 92.08% respectively. The best coagulation conditions of PFS show that, the dose of PFS 、 PAM 、 Powdered activated carbon is 500mg/L 、 4.0mg/L and 1.0g/L respectively, pH is 6.8~7.2 and the precipitation time is 30min. Then the removal rate of COD、 Color is 64.55% and 94.33% respectively. The best coagulation conditions of PAFC show that, the dose of PAFC 、 PAM 、 Powdered activated carbon is 300mg/L 、 3.0mg/L and 1.5g/L respectively, pH is 8.0 and the precipitation time is 30min, then the removal rate of COD、co