GSM无线资源的管理讲解.pptVIP

MAIO Offset parameter (MO) defines the lowest value of the MAIO used in the Cell. This allows using the same MA in all of the sectors of the Site. The advantage is that with the same band and the same re-use, the number of frequencies in the MA increases 3 times with much higher protection against both -fading - interference The idea is of course that the parametrization is such as to avoid collision between different physical channels. This means that the same frequency cannot be used (at the same time) by two different TRXs in the site. The following must be fulfilled. Hopping Sequence number has to be the same in all of the sectors, otherwise collisions will take place regularly. Sectors must be frame synchronized i.e. the FN must be the same for all of them all of the time. N1, N2 and N3 are the numbers of TRXs in the three sectors. Then the number of Frequencies in the MA list must include at least (N1 + N2 + N3 - 3) frequencies. The frequencies in the MAL are ordered in the descending order in respect to Fruquency number MO is 0 in the first sector, N1 - 1 in the second and N1 + N2 - 2 in the third sector. Two mistakes in the documentation HSN is only one in RF FH. 128 possible MAL can be defined in BSC each with max 63 frequencies. MaioStep MS = decimal number With this parameter you choose the MAIOs not to be allocated successively for the cell, but for instance every second or every third value. The values range from 1 to 62. However if the MAIO step is more than 1 ,the number of the frequencies in the MAL should be doubled, trippled … and so on.Otherwise there would be collisions , and the NMS will complain that MAL is short. You can only modify this parameter when the BTS is LOCKED, underlay TRXs are LOCKED or the underlay hopping mode is not RF hopping. Directed Retry is an Optional Feature and has to be enabled in the BSC. The command ZWOO; lists the optional features in BSC and their status of activation. Directed