甲醇重整制氢耦合温差发电特性及催化剂稀释的影响分析-analysis of coupling thermoelectric generation characteristics of methanol reforming hydrogen production and the influence of catalyst dilution.docx

and mass transfer restriction, and the phenomenon fades with the increase of reactor temperature. Further experiments with different catalyst dilution ratio distribution were carried out. Comparing the performance of uniform distribution of catalyst with the catalyst distribution form I, the catalyst distribution form II and the catalyst distribution form of inverse function with each other, and the minimum cold spot temperature difference, the highest methanol conversion and hydrogen production rate can be achieved in catalyst distribution form I, results further indicate that the bigger the catalyst dilution ratio is, the smaller the cold spot temperature difference is and the closer the location of the cold spot is; the cold spot temperature difference could be contracted by raising the catalyst dilution ratio in a way, and it is the same with methanol conversion and hydrogen production rate improving. However the catalyst dilution rate could not be too high or it will result in a decreasing of actual reaction time, then leading to the decrement of methanol conversion rate and hydrogen production rate.Keywords: methanol steam reforming; hydrogen production; micro reactor; catalyst dilution; thermoelectric power generation目录中文摘要..........................................................................................................................................I英文摘要........................................................................................................................................ II主要符号表 .................................................................................................................................VI1 绪论.............................................................................................................................................. 11.1 课题研究的背景与意义........................................................................................................... 11.2 国内外的研究现状................................................