贵州大湾煤矿0.9Mta新井设计（机械CAD图纸）.doc

摘 要 本设计包括三个部分：一般部分、专题部分和翻译部分。 一般部分为贵州大湾煤矿0.9Mt/a新井设计。大湾煤矿位于贵州省六盘水市西北面，交通便利。井田走向长约5.6 Km，倾向长约1.8 Km，井田总面积为10.08 Km2。主采煤层为11号煤，平均倾角为7.07°，煤层平均总厚为4.16m。井田地质条件较为简单。 井田工业储量为7715.90万t，矿井可采储量5370.26万t。矿井服务年限为45.9a，涌水量不大，矿井正常涌水量为60m3/h，最大涌水量为80m3/h。矿井瓦斯涌出量5.1m3/h，为高瓦斯矿井。 井田为双立井单水平开拓。大巷采用电机车牵引3T底卸式矿车运煤，辅助运输采电机车牵引1T矿车。矿井通风方式为分区并列式通风。 矿井年工作日为330d，工作制度为“三八”制。 一般部分共包括10章：1.矿区概述及井田地质特征；2.井田境界和储量；3.矿井工作制度及设计生产能力、服务年限；4.井田开拓；5.准备方式-带区巷道布置；6.采煤方法；7.井下运输；8.矿井提升；9.矿井通风与安全技术；10.矿井基本技术经济指标。 专题部分题目是“煤与瓦斯突出防治新技术”。 翻译部分题目是“新技术和新理论的采矿业跨世纪发展” 关键词:大湾煤矿；开拓设计；回采巷道。 ABSTRACT This design consists of three parts: the general part, the special part and translated part. The general part is a new design of GuiZhou da wan mine. Da wan mine lines in west of liu pan shui in GuiZhou province. The well field moves towards long approximately 5.6km, thetendency long approximately 1.8km，the area is 10.08k㎡.The three and 11th is the main coal seam, and its dip angle is 7.07 degree. The thickness of the mine is about 4.16m in all. The well field geology condition is simple. Well-field is pair of inclined shaft Shan level developing , level altitude be 470 m. Big alleys adopt adhesive tape to transport odds coal , assist transportation to gather trackless rubber tyre vehicle. Mine ventilation way is a central authority march-past ventilation. The working system “Three- eight” is used. It produced 330d/a. This design includes ten chapters: 1.An outline of the mine field geology; 2.Boundary and the reserves of mine; 3.The service life and working system of mine; 4.development engineering of coalfield; 5.The layout of panels; 6. The method used in coal mining; 7. Transportation of the underground; 8.The lifting of the mine; 9. The ventilation and the safety operation of the mine; 10.The basic economic and technical norms. Special subject part examination questions is that the coal and gas protruding prevention and cure new technology . The translation part isdeveloping of trans-century mining subject with new