连续退火炉加热段模型化及动态响应分析-modeling and dynamic response analysis of heating section in continuous annealing furnace.docxVIP

AbsractContinuous annealing furnace has high efficiency of heat treatment. It mainly produces strong tensile strength and strong plastic strip. The strip temperature control of heating section directly influences the quality of the products . Heating section is the most critical annealing furnace section. Therefore, the study of heat transfer process, modeling, and dynamic response, based on the characteristics of the heating section, is the key to realize the annealing process optimization and improve the continuous annealing technology.In this paper, the Heat Transfer analysis, Modeling and Dynamic response of variable conditions researches have been carried out for the heating section of a vertical continuous annealing furnace. Based on the characteristics of structure, technological process and heat transfer, a model is proposed ,which includes set point calculation function, temperature tracking function and productivity calculation function. By using unit partition method, the model of the heating section has been established. By using equivalent plane method and imaginary plane method, the radiant heat transfer system has been established. Toimprove the treatment of furnace wall ， a heat transfer model of furnace wall andenvironment has been imported. To establish the dynamic model of heating section, a combustion model in the radiant tube has been imported. A preliminary study of dynamic response of heating section under variable conditions has been developed.Based on the established model of the heating section, the three functions of the calculation have been achieved, by using C# programming language. Use CFD simulation to validate the rationality of the equivalent plane method. Calculating the strip temperature curve and furnace temperature set value by using the established steady-state model, and comparing the values with the strip technology curve in the vertical furnace specification and the actual measured furnace temperature, the result