毕业设计（论文）基于PLC的Z3040摇臂钻床传统电气控制系统改造.docVIP

毕业设计（论文）--基于PLC的Z3040摇臂钻床传统电气控制系统改造 专科毕业设计论文 设计题目 基于PLC的Z3040摇臂钻床电气控制系统改造 系 部 电气工程系 专 业 工企电气 班 级 工企 姓 名 丁统平 学 号 7 指导教师 季明丽 职 称 副教授 2012年6月 南京 摘 要 传统继电器接触器电气控制系统的线路复杂可靠性稳定性差故障诊断和排除困难由于PLC电气控制系统与继电器接触器电气控制系统相比具有结构简单编程方便调试周期短可靠性高抗干扰能力强故障率低对工作环境低等一系列优点因此本文对Z3040摇臂钻床电气控制系统的改造将把PLC控制技术应用到改造方案中去从而大大提高摇臂钻床的工作性能论文分析了摇臂钻床的控制原理制定了可编程控制器改造Z3040摇臂钻床控制系统的设计方案完成了电气控制系统硬件和软件的设计其中包括PLC机型的选择IO端口的分配IO硬件接线图的绘制PLC梯形图设计程序对PLC控制摇臂钻床的工作过程作了详细阐述论述了采用PLC取代传统继电器接触器电气控制系统从而提高机床工作的性能的方法给出了相应的控制原理图 关键词 PLC 摇臂钻床 梯形图 电气控制系统 Abstract This paper is to study the mechanical processing used in Z3040radial drilling machine transformation of the traditional electrical control system aimed at resolving the traditional relay - contactor electrical lines exist in a complex control system reliability stability fault diagnosis and rule out the difficulty As the PLC control system and electrical relay - contactor electrical control systems has the advantages of simple structure easy programming debugging a short cycle high reliability strong anti-jamming ability low failure rate low range of advantages to working environment Therefore this article on the Z3040radial drilling machine electrical control system transformation will use the PLC control technology is applied to the scheme thereby greatly improving the working performance of the rocker drilling machine The paper analyzes the control principle of radial drilling machine developed PLC Z3040radial drilling machine control system design completed the electrical control system hardware and software design including the PLC type selection IO port allocation IO wiring diagram of the hardware rendering PLC ladder diagram design program The PLC control arm drill working process were discussed in detail discusses the use of P