高频开关电源的高效集成单周期控制策略分析-analysis of high-efficiency integrated single-cycle control strategy for high-frequency switching power supply.docx

soft-start scheme is proposed and successfully applied to typical voltage mode DC-DC switching converters. Simulation results show that when starts up, the maximum overshoot by the proposed soft-start scheme is less than that with the conventional scheme by 5% under the same condition.A fully integrated one-cycle controller chip for high frequency, high efficiency DC-DC converter is designed. The key techniques of controller circuits are studied. A design of high intrinsic accuracy bandgap reference for current-mirror mismatch is proposed. The simulation results show that the error caused by current-mirror mismatch has been reduced by about 50 times in the proposed bandgap core. Moreover, optimum design of oscillator and transductor amplifier circuits are also presented. The compact soft-start circuit and PWM/PFM detector are designed to realize soft-start and mode-switching functions.Finally, based on BCD 0.6μm technology, a fully integrated one-cycle controller chip for high frequency, high efficiency DC-DC converter is realized. The simulation results successfully verify the control principle and show that the converter can implement high-efficient voltage conversion (maximum 94% efficiency). When starts up, the output volage rises stably with maximum 2.9% overshoot. The controller demonstrates equal or better transient-response performance compared to state-of-the-art analog switchers. Moreover, the controller can be fully integrated which results in lower cost.Keywords: DC-DC converterOne-cycle control schemeHigh efficiency PMW/PFM dual modeSoft startBandgap reference circuit独创性声明本人声明所呈交的学位论文是我个人在导师指导下进行的研究工作及取得的研 究成果。尽我所知，除文中已经标明引用的内容外，本论文不包含任何其他个人或 集体已经发表或撰写过的研究成果。对本文的研究做出贡献的个人和集体，均已在 文中以明确方式标明。本人完全意识到本声明的法律结果由本人承担。学位论文作者签名： 日期：年月日学位论文版权使用授权书本学位论文作者完全了解学校有关保留、使用学位论文的规定，即：学校有权 保留并向国家有关部门或机构送交论文的复印件和电子版，允许论文被查阅和借阅。 本人授权华中科技大学可以将本学位论文的全部或部分内容编入有关数据库进行检 索，可以采用影印、缩印或扫描等复制手段保存和汇编本学位论文。本论文属于保密□，在年解密后适用本授权书。不保密□。（请在以上方框内打“√”）学位论文作者签名：指导教师签名：日期：年月日日期：年月日1绪论1.1 研究