硕士论文-基于以太网及现场总线选煤厂控制系统研究.doc

分类号：TP24 密 级： 公 开 UDC： 单位代码： 学 位 论 文 基于以太网 及现场总线的选煤厂控制系统研究 May 2005 声 明 本人呈交给山东科技大学的这篇硕士学位论文，除了所列参考文献和世所公认的文献外，全部是本人在导师指导下的研究成果。该论文资料尚没有呈交于其它任何学术机关作鉴定。 硕士生签名： 日 期： AFFIRMATION I declare that this dissertation, submitted in fulfillment of the requirements for the award of Master of Philosophy in Shandong University of Science and Technology, is wholly my own work unless referenced of acknowledge. The document has not been submitted for qualification at any other academic institute. Signature: Date: 摘 要 选煤厂集中控制是指对选煤系统中有联系的生产机械按照规定的程序在集中控制室内进行启动、停止或事故处理的控制。本文针对选煤厂的实际控制要求，开发了基于工业以太网及现场总线的过程控制系统装置。 本文介绍了选煤厂生产工艺对集中控制系统的要求，对主要设备进行简单阐述，对洗煤厂工艺流程进行了研究，为网络控制系统装置的开发工作做了充分的准备。在此基础上，阐述网络控制系统的组成、结构及特点和SIEMENS S7系统工业通讯网络，并说明了SIEMENS S7系统的通讯协议、通讯方式、网络控制系统的开发平台、硬件配置及开发软件。针对网络控制系统软件设计与功能实现，详细说明了PLC系统的硬件组态、网络组态、硬件下载及编程，并介绍了WinCC与PLC的通讯组态、WinCC图形画面组态。 关键词：选煤，工业以太网，现场总线profibus-dp，WINCC组态 ABSTRACT The central control of the coal selection factory is to control the process in a fixed program, such as the start, stop, and failure of the machine which is connected to each other .This passage, aiming at the practical control demand, has developed the process control system which is based on the industrial Ethernet and Profibus-dp. This passage has introduced the demand for the central control system according to the working procedures of coal selection, illustrated the main equipments in brief, and also studied the procedure of coal selection, which has supplied enough preparation for the development of the network control system. What’s more, this passage has illustrated the structure, composition, characteristics, and the S7-industrial communicatio