抑制混合载波调制系统的峰均功率比的分析-analysis of suppressing peak-to-average power ratio of hybrid carrier modulation system.docxVIP

生现象，本文使用第一种多次削峰滤波技术与第二种多次削峰滤波技术抑制混 合载波系统 PAPR。通过仿真得到削峰滤波次数越多，系统 PAPR 越小，系统 BER 越大。与第一种多次削峰滤波技术相比，第二种多次削峰滤波技术能更有 效地抑制系统 PAPR，但是 BER 增大的更多。最后，本文对在混合载波系统中 使用的削峰类技术的优缺点进行了比较总结。本文的研究结果对于在实际混合 载波系统中使用削峰类技术联合其它相关技术抑制混合载波系统 PAPR 的研究 有一定的借鉴作用，接下来研究工作的重点将放在混合载波系统接收端信号削 峰噪声的消除，以提高系统 BER 性能。关键词：混合载波调制系统；峰均功率比；加权分数傅立叶变换；过采样；削 峰技术；削峰滤波技术AbstractIn recent years, Hybrid Carrier (HC) systems based on 4-weighted fractional Fourier transform (4-WFRFT) have been proposed, and the system can transmit simultaneously single-carrier (SC) and multi-carrier (MC) at the time-frequency domain. It is a real HC system in blend of SC and MC characteristics. HC based on 4-WFRFT contains MC modulation signals, and when a plurality of signals with the same phase are superimposed, it may produce relatively large transient spikes. So there is peak to average power ratio (PAPR) problem in HC. High PAPR causes nonlinear distortion of amplified signals from Power Amplifier (PA), and also reduce PA efficiency and signals coverage, etc. High PAPR will also require the median increase of digital to analog converter (DAC), which would increase the cost of the DAC device. Therefore, high PAPR is always a major problem which limits the development and the application of HC systems. In this article, We research on reducing the PAPR and related issues for HC system.In order to make the HC discrete-time signals approximate the continuous-time signals in PAPR, we propose an oversampling method for HC discrete-time signal, and the average power and the power spectral density of oversampled signals are analyzed. Through the simulation and analysis of the oversampled signals in PAPR performance, we conclude that when the oversampling rate L=8, the baseband discrete-time signals can accurately reflect the PAPR performance of the baseband continuous-time signals.We use Clipping technique to suppress HC system PAPR. By HC systems simulation, we can get that Clipping processing introduces in-band noise and out-band rad