Select and Understand The Use of Repair Finishing Systems and System Parts课件.ppt

Module 4B2 Select and Understand The Use of Repair Finishing Systems and System Parts Methods of Refinishing - Touch-Up Refinishing Used to repair minor scratches and chips Uses sanding, brush painting, and polishing Does not use a spray gun Methods of Refinishing - Spot Refinishing Small areas Requires primer-surfacer or primer-sealer Requires blending of topcoats Methods of Refinishing - Panel Refinishing Same technique as spot repair Includes entire panels (hoods, doors, etc) May require blending Methods of Refinishing - Total Body Refinishing Refinish entire vehicle Reasons: Number of spots repaired Dull, cracked, worn finish Direction of customer Surface Analysis - Determining a Good Surface Good surface has minor problems: Stone bruises, off-color, orange peel Poor surface has major problems: Defect affects the entire thickness or a large area Deep scratches, rust, lifting, peeling, runs, sags Poor finishes must be removed to substrate Determining Make-Up of Existing Area - Determining a Refinished Vehicle Visual inspection Signs of taping, shading, color of undercoating Evidence of bodywork Sanding Determining Make-Up of Existing Area - Determining a Refinished Vehicle Measuring paint film thickness Should not be more than 8-10 mils 1 micron is 1/300 of a millimeter 1 mil equal to 1/1000” (25 microns) Typing paper is 4 mils, standard paint is 4-5 mils Measure using a thickness gauge Compatibility - Selection of Applicable Paint Acrylic urethanes and urethanes can be used over most old or refinished paints Paint Labels and Codes - Paint Code Labels Have information on paint codes, trim codes, and interior colors Information: Type of paint Upper and lower exterior paint Trim combination Paint Labels and Codes - Location Varies depending on make and model Paint Labels and Codes - GM Paint Labels and Codes - Ford Paint Labels and Codes - Chrysler Paint Labels and Code