能量隔离安全培训教材20151130 ppt课件.pptVIP

执行上锁挂牌验证程序时须辨识所有能量源 只有有资质的人才能操作上锁挂牌设施 设备上锁挂牌后必须验证锁定的有效性 由有资质的人去除最后的锁定装置前必须确保工作已完成并且设备恢复到可安全操作状态 总结 * 各部门应根据现场的实际情况，在辨识危险能量时参照前述能量形式进行全面评估。 * This dramatic accident resulted from a series of short cuts taken on the plant energy isolation procedure. Additionally, this procedure was based EXCLUSIVELY on paper, i.e. on the principle that each individual’s safety relies on other people. There was no physical block (padlock) preventing the restoration of power. * Prior to entering the kiln, any air blaster should be manually fired and mechanically shut-off using a lock on a ball valve * Remember 1 Equipment - 1 man - 1 lock - Ask for additional Padlocks if required After Isolation (LOTO) Test Start – Verification * * * * * Once the machinery or equipment has been correctly disconnected or isolated from its energy sources it must be locked out, tagged out and tried out . Locks and tags shall be singularly identified and not used for any other purpose. * All Lafarge employees and contractors who perform tasks on machinery or equipment must be issued personal locks and tags. regardless of the duration of the job or their proximity to the energy isolating device. * The 9 steps outline the mandatory LOTOTO sequence that shall be followed prior to performing any task on machinery or equipment. * The training must include the recognition and control of hazardous energy, an understanding of the terminology and principles outlined in the advisory, practical field training, the requirements of the Group EI Standard, site rules, and local regulations. * Lafarge businesses are expected to comply with all local laws and regulations that may be more stringent than the information presented in the advisory * * Whenever we are going to do a work requiring completion of an energy isolation we must follow Six Principles of Energy Isolation that we have just discussed. 1. Identify what type of energy we are likely to encounter? 2. Make clear – how we are going to isolate the sourc