水性油墨用颜料分散研究.docVIP

THYON SRT3069 PIGMENT DISPERSION REPORT-Lithol Red-立索尔大红颜料分散的研究 Inks technology laboratory 油墨技术实验室 青岛琳可工贸有限公司蔡迎阳译 Introduction介绍 The water-based inks market is steadily growing and increasing. Modern ink formulation requires very good printability at high printing speeds, higher pigment concentration, higher gloss, and enhance chemical and mechanical resistance. Ink manufacturers mainly need very stable rheological properties and low viscosities to allow process optimization and higher pigment load.Based on these requirements, Diransa San Luis S.A. developed THYON SRT3069 to satisfy this important market demand, especially for red pigments.This report shows the behavior of THYON SRT3069 with Red Pigment PR 49.1 and PR 57.1.THYON SRT3069 is also compared with a high dispersing grade resin available in the market 水。高速，，更高的光泽度，并增强化学和机械性能。所以 基于这些要求， Diransa San Luis S.A.发THYON SRT3069以满足市场需求，尤其是对红色颜料THYON SRT3069 与市场上具有高级分散的树脂对颜料49:1 和 57:1进行对比试验，报告如下： STARTING FORMULATION基础配方 Resin solution树脂液 Ingredient配比 Quantity THYON SRT3069树脂 32,0 Ammonia 26o氨水 8,5 Defoamer消泡剂 0,2 Water水 59,3 PH 8.9 Viscosity [cP]粘度 1200 Grinding Pigment 研磨色浆 Ingredient Quantity Pigment 颜料 35,0 Resin solution树脂液 30,0 Defoamer消泡剂 0,1 Water水 34,9 Formula design配方设计 The resin solution is manufactured on base of THYON SRT3069, allowing the manufacturing of high solid, low viscosity and better wetted pigment dispersions. In this report, we use Ammonia and water to dissolve the resin. THYON SRT3069 此树脂液适于生产高固含，低粘度，色浆具有优质的润湿分散性。此实验报告是用氨水来溶解的树脂，在应用中也可以根据需要使用其它有机胺类。 Procedure 操作 Vibro-Mac lab mill of 1.5 kg capacity was used to grind the pigment. The beads were Zircosil (2-2, 4 mm). ** Grinding times: 1.5hs, 3hs and 4.5hs. 用1.5公斤的实验室用研磨机研磨颜料，锆珠2-2.4毫米 。 研磨时间 ： 1.5小时，3小时，4.5小时 **TM Jyoti Ceramic Industries RESULTS结果 During the grinding process, solid partic