__平板印刷工（Tablet printer ）.doc

__平板印刷工(2)（Tablet printer (2)） 1. The untortoise line in printing is (). (answer: B) A square point B FM node C round point D chain point 152. Which of the following colors is the original color (). (answer: C) A deep red B black C magenta D blue 153. According to the industry standard, the printing of fine print is allowed to be (). (answer: B) A is less than 0.01 mm B is less than 0.10 mm C or 0.20 mm D is less than 0.30 mm 154, the hardness of the rubber cloth is related to the printing resistance rate and the branch transfer, usually the rubber cloth hardness is about the degree of Shore A () degree. (answer: C) A 30 ~ 45 B 50 ~ 70 C 75 ~ 85 D 90 ~ 95 In general, the pH value of the moistable liquid of the PS version is 5 ~ 6, and the conductivity requirement (). (answer: B) A 600 ~ 800 B 800 ~ 1200 C 1100 ~ 1600 ~ 2000 156. In the process of offset printing, the emulsification of () is not only inevitable, but necessary. (answer: B) A water pack oil B oil and water C oil-water soluble D oil separation 157. In the case of the offset printing press, it must be performed in () case. (answer: C) A shutdown B power failure C is in safe condition D to cut off the gas source 158. The density of the quality of the printed matter should be selected (). (answer: B) It doesnt matter that the density value C A + B D has just been printed The ratio of water film thickness to ink film thickness is approximately (). (answer: D) A 2:1 B 1:4 C 3:1 D 1:3 160. Surface tension of ink surface tension (). (answer: B) A is greater than B and less than C is equal to 161. Offset press drum gear mostly adopts () pressure Angle. (answer: C) A 20 ° B 17 ° 15 ° and 14.5 ° C 162. The zero of the offset machine means (). (answer: A) A paper teeth begin to pick up the paper point B and the contact point C paper suction nozzle to start the paper point D print drum and paper drum 163. Most domestic offset printing presses adopt () lateral pull gauge. (answer: B) A pneumatic B roller type C magn