五岳压力表p206英文手册.docVIP

PW206 digital pressure controller New Features This controller has two-layer structure, top for displaying actual pressure and bottom for set pressure. It has top and bottom limit alarms, two sets alarm,outputing by relay contact point . It can output by constant current and voltage,4-20mA or 0-10 V linear output analog data. It also can connect to the PLC and other controllers directly with automatic panel calibration function which makes the calibration much easier like just pressing some keys. This controller also adopts light and electricity insulation, watch dog, software wave filtering these three types anti-interference technology. It ensures the reliability of the system. This controller supplies by switch, so it can work at 120V low voltage conditions. This controller is widely used in the petroleum, chemical fiber, and plastic industry. It can used with the normal controller for pressure test and control at normal temperature. Based on PW200 series, PW800 series are one new generation of intelligent instruments. Main technical details Item Description Display Two-layer structure, top for actual pressure and bottom for set pressure Internal Resolution 32000 External Resolution 0..1 MPa,0.02MPa,0.05MPa data save for more than 40 years after disconnection Power supply 220VAC(120V-250V) Range 0~99.99MPa Relay rating 250VAC 5A Operating environment -10-55℃, ≤99% RH Dimension 96X96 X 100mm Configurable output for pressure 4~20mA, 0~5V, 0~10V optional 2.Configuration and overall dimension PV display :LED large nixie tube for display the current pressure. It will display parameters` code name while you change the parameters. SV display: LED small nixie tube for display the top limit pressure(AL1). It will display the current parameter which you are revising. Introduction of keypad CE: zero clearing button. CAL: calibration button (Automatic calibration button). ⌒:Shifting button : Move button ∨:Decreasing value button ∧:Increasing value button Int