泰克rfid及物联网解决方案.pptVIP

DDR/SDRAM/FLASH内存总线检测调试、频域分析软件 * 自动测量软件根据选取的标准，以及测试对象（读卡器 或 标签），自动配置测量参数，完成调制域和码域测试；并且能够实现自动波特率估计 或自动Tari估计 * 按照地方法规规定实施。RFID自动测量软件，根据设置的门限功率，自动判断和测量杂散信号 * * * * 泰克专利DPX技术，实现48000次/秒的频率更新速度，并实现同频信号监测，能够准确分析跳频以及同频信号。左图为DPX观测100ms的结果，右图为传统扫描频谱仪30秒后的结果。很明显，使用DPX技术不仅测量时间短，而且能够清楚的看到RFID占用的有效信道，以及受到的干扰情况。 The first step in evaluating RFID system performance is to use the RSA3000B Digital Phosphor display known as DPX?, or Live RF, to evaluate what is happening in the frequency span of interest. With DPX, the X axis (Horizontal) is still frequency and the Y axis (vertical) is amplitude as in a conventional spectrum display. However DPX adds unique hardware which allows for processing over 48,000 spectrums/sec and allows for temporal , or time-based, information. The longer a signal dwells at a particular frequency and amplitude, the darker red it will be to show the higher signal density. You can also adjust the persistence, meaning how long the signal is displayed before it fades from the screen. IN this slide, we see DPX on the left versus swept analyzer display on the right after 30 seconds. Note that, on DPX display, all the channels are captured in the Max hold (green trace). You can also clearly see where some interfering signals are present which is not possible to see on a swept analyzer. With DPX (Live RF) you can: See other RFID channels and systems used in the same band Discover other ISM band devices that might be present (two-way radios, cordless phones, Zigbee devices, etc) Detect the potential for interference and system degradation For the UHF band in North America, we would press the DPX button on the front panel of the RSA3408B, then tune the RTSA to a 915 MHz center frequency and a 36MHz span. This span allows for capturing the entire 26 MHz of interest as well as monitoring the modulation sideband behavior of both channel 1 (centered at 902.75 MHz) and channel 50 (centered at 927.25 MHz). DPX display of the hopping signals from a reader where the s