轴承端盖冲裁模具研制业设计（论文)word格式.docVIP

轴承端盖冲裁模具研制 摘 要：本文主要介绍加工端盖制件落料、拉深、冲孔的复合模——是在压力机的一次行程中，在模具的同一工作位置上完成这三道工序的冲模。 因此合理地布置凸、凹模，设计复合模的结构，分析复合模的工作原理及进行工艺设计是要解决的重要问题。其内容包括总的压力计算，压力中心的确定，凸、凹模工作部分尺寸计算，绘制装配图和零件图，编写工艺过程卡等。 关键词：工作原理 结构设计 计算 绘图 复合模 Blanking die of Bearing End Cover Part Research and Manufacture Abstract：This mainly introduce the compound die which is applied for producing End Cover Part, blanking, drawing and punching. In one press stork, the three producing courses are complished in the same position of the die, which shapes the compound die. Therefore, properly disposeing punch and die, designing the stracture of the die, always analysesing the operation principle and craft design of the die are becoming the most significant point. It aims at the total pressure calculateion, confirmation of pressure center, measurement calualation of the punch and die, drawing assembly graph, redacting craft prollessing cards and so on, of course, which is also the main content we are going to talk about. Keywords：Operation principleStructure Design Calculate Drawing Compound die 目 录 第1章 绪论.......................................................1 第2章 复合模的设计基础...........................................2 2.1 冲裁变形机理..............................................2 2.2 拉深变形机理..............................................3 第3章 工艺分析及计算.............................................4 3.1 工艺方案的分析和确定......................................4 3.2 端盖复合模具中有关计算....................................5 3.3 初选压力机................................................9 3.4 计算压力中心.............................................10 3.5 凸凹模工作部分尺寸计算...................................10 3.6 橡胶的选用...............................................15 第4章 模具总体结构设计..........................................18 4.1 初定模具闭合高度.........................................18 4.2 落料、拉深、冲孔复合模结构...............................18 第5章 模具主要零件的设计与选用..................................20 5.1 工艺性零件...................................