高速网络拥控制研究硕士毕业论文.docVIP

硕士学位论文 论文题目 高速网络拥塞控制研究 英文题目 Research on Congestion Control for High-Speed Network 硕士研究生 指导教师 学科专业 论文提交日期 论文答辩日期 论文评阅人 答辩委员会主席 2009 年 月 日参数，并且采用非线性函数代替原有的丢包率计算方法。通过动态调整来调整向源端发送拥塞通知的速率，维持队列的稳定；通过新丢包率计算方式，提高缓冲的利用率和使队列长度尽量稳定于期望值附近。最后通过仿真来验证新算法更适应网络流量的变化，保持队列长度的稳定和丢包率的稳定，从而提高了网络链路利用率。 关键词：高速网； 拥塞控制； TCPW； RED Abstract With the development of the applications on high-speed network, research on congestion control becomes more and more important. Congestion control should include two parts: end-to-end control and link control. End-to-end control could adjust the data sending rate dynamically in order to respond to link congestion. On the other hand, the link control can predicate and monitor the degree of congestion effectively, then send the warning to sender before congestion happening by explicit or implicit method. Now more and more scientists begin on the researches of the TCP congestion control mechanisms for high-speed networks and this research has become a focal subject. There are some typical protocols:, such as STCP, H-TCP,TCPW etc. These new protocols enhance the performance on the high-speed networks through adjusting the increases and decreases mode of window, TCPW algorithm is a better one, it is based on BWE (Bandwidth Estimation) and has little changes on TCP protocol. it also provides a sensible fairness increment with respect to TCP Reno, Moreover, TCPW is friendly to Reno. But there are still some shortages in it, Congestion window of TCPW is based on additive increase of linear mode. So, in high-speed networks it can’t obtain high throughput rapidly. During the slow-start stage, the congestion window of TCPW is based on exponential growth mode, then this will cause the datagram increases too fast and prompt th