3XLS1000操纵器部件.pptVIP

HONEYWELL;XLS1000 SYSTEM COMPONENTS;The 3-PPS Primary Power Supply is:;The 3-CPU or 3-CPU1 Panel Controller:;The 3-PSMON Primary Power Supply Monitor Module;These components are required in every XLS1000 Cabinet:;RS-485 CARD;3-FIB or 3-FIB1 Fiber Optic Cards;1. Maximum #14 AWG wire: minimum #18 AWG. 2. All shields, if used, must be continuous and insulated from ground, except at the originating panel.;PLUG FRONT;PLUG FRONT;A B;Network Down Loading Class B;Down Loading;Note: In the case of an older system wired Class B, where it is not convient to connect to the panel without a “A” connection, you can always download via ANY panel’s RS-232 port without any trouble!;Lets take a look at Network Audio Wiring;Class B;The Backup Amp Wiring has also changed.;3-RS485 Card Discontinued Provides network for systems with 3-CPUs Provides: Class A B Network Data Riser Class B Network Audio Riser Replace with the new 3-RS485R when ordering replacement parts.;3-RS485B Card Transitional - New Provides the same features as 3-RS485R Card but is used only on 3-CPU1s. Provides: Class A B Network Data Riser Class B Network Audio Riser Will eventually be phased out by the 3-RS485A Card;传沦硫衣向惠桨摇牛调姑宾堰捐梅洗瓤贰溃械团磨差肉秽淡烦骆仓伍毛艺3.XLS1000控制器部件3.XLS1000控制器部件;If an operator interface is desired:;The XLS1000 offers four Control/LED Displays which mount on top of single local rail modules.;A Control/LED Display comes with a ribbon cable that is plugged into J1 of the local rail module. If a Control/LED Display is not used on a local rail module, a blank off-plate may be used to fill the empty space. ;OPTIONAL COMPONENTS OF THE XLS1000 FIRE ALARM NETWORK;3-BPS Booster Power Supply;3-SSDC Single Signature Device Controller Signature Data Card;3-DSDC Dual Signature Device Controller Signature Data Card;1. Maximum #14 AWG wire; minimum #18 AWG. 2. Maximum 79 Ohms resistance per circuit for Class A and Class B configurations. 3. Shields, if used, must be continuous and